Cost of moving an electrical outlet? - relocate electrical outlet
While rebuilding was not an outlet as planned moved and is now behind the mountains about four inches to the left. You can see about an inch from the top of the exit at the top of the range. Of course, that sounds stupid and is not usable in its current position. I would not begin to open the drywall and insert again (I'm so with that). I am not qualified to be an electrician to do the job instead of trying to convince her husband about it, not (at this point he is tired and wants only to rebuilding the splash tile just above the main - but could really) those products in the FTA. Is it difficult to go on foot (it's a stud between the two locations). ThanOr you can do without a large piece of drywall?
Friday, February 19, 2010
Relocate Electrical Outlet Cost Of Moving An Electrical Outlet?
Subscribe to:
Post Comments (Atom)
2 comments:
The output can be easily moved. Simply remove the patch on the one hand, the end of the range "as you want the output to be. Then remove the baking sheet and renail about 1 cm. Tie a thread of this problem to a new level where he wants. Sheetrock between the two, joint compound, tape, float, sand, primer and paint and nothing else.
The maximum time to complete: less than 6 hours.
Alternative: Call a motion electricial painting for $ 200. Then call a handyman for plaster / paint for $ 300. You need to leave it about $ 500. Not bad for having killed two birds with one stone.
I would say that when it comes to an outlet that is not used then to get one of these flat tops and close easily.
If you do not flush with the pavement, you can use a wooden tooth CHISSEL in the drywall around the defected to the disk immediately below the surface of the drywall a little.
Well, when it closes, it will be on the surface of the wall in the vicinity.
Within taken:
1. connected all cables to loosen the plug. If you have more than one thread of each color (black, white, ground), wrap all the son of the same color, they are with a wire nut and electrical tape splice.
Stick fairly well, and then just put it in the foreground of the cover plate of the outlet box.
Relocating a new departure:
The output step is to reduce the hole in the box, run a line of this issue (cables nuts) of this new market. To install a junction box, plug the cable, put the card in the box and covered with a lid. The hardest part is cutting the power supply and the line snakes more. ...... Maybe you can surf on the surface of the wire through the tube (behind the stove) from her eyes.
Post a Comment